This post is a mixed bag.
From the back end you get an idea of Shrox designs, certainly not a four fin model with the fins spaced at an even 90 degrees.
(Yeah, I know - there are five fins here.)
I cut a higher spine that is between the two wing fins.
This was done so it could be sanded to surface afterwards.
Originally the plan was to sand the spine flat and keep the top square.
In the end it was slightly rounded off.
I looked ahead at the canopy decal placement.
On the old Nike Smoke nose cone there is an molded antenna (I believe it's an antenna) that would sit under the front center of the decal.
Like the hatches this will be sanded off.
No comments:
Post a Comment