Semrock IQSY Tomahawk Build Part 13 Fin Plates and Telemetry Wrap

I pressed a piece of paper into two facing root edges to get the (body tube span) width of the fin plates. It was right around 5/8".

Using the scale data I started drawing the fin plates, bolts and the telemetry antenna wrap.


Using scale data from four different sources I found that:

• Three fins are white, one fin is black.
• The flush telemetry antenna is centered between the black and white fin.
• The bolt heads on the nose cone and telemetry section are aligned with each other
• A fin plate without the center line (three bolt centers) goes between the black and white fin. The rear line of the plate is.187" from the end of the tube.
• As near as I could figure, alternate the three and four bolt center plates between the fins.