Out of curiosity I glued together the transition shroud that came with the clone kit.
I knew it would be small. Earlier it was checked against the length of the root edge of a sustainer fin.
The printing was faint and pixeled. I had to draw the line in for the glue tab.
This is the wide end against the diameter of a BT-50 upper stage.
The inset shows the shrouds side by side.
On the left is the transition that came with the clone kit.
On the right is the correct size shroud made on PayloadBay.com and printed on 110 lb. card stock.
No comments:
Post a Comment