Sunday, September 2, 2012

Midget Clone Build Part 7 Engine Blocks


I had a hard time getting the thin engine blocks to fit into the mount tubes.

The burr around the top of the upper mount had to be rolled over with a smooth dowel. Again, pre-fit any rings before using glue.



This is the back end of the booster body tube.
A second thin EB-20B engine block is glued into the low end (or rear) of the booster tube.

After the white glue dried, some CA was applied with a Q-Tip.
After sanding with 400 grit on a block, here's how the joint looked.

No comments:

Post a Comment