Estes Skydart II #3229 Build, Part 14, Ends and Edges

I added a fillet of Titebond M & TG to the front and rear of the wing.

I didn't do a fillet along the inside down the tube wing joint. I've learned from past experience that a deep fillet won't dry without plenty of bubbles.

The elastic holes in the rudder and elevator were rounded using a small diamond rat tail file.








Before applying any glue to the nacelle tube edges, do a dry fit.
Try to set them on the line without too much sliding around. Once glue is applied on the edges you'll want to place them without glue tracks all over the tube.