Monday, March 26, 2012

Dr. Zooch Flame Fins Part 3

The fins got a coat of thinned CWF and were sanded with 400 grit on a block.
The angled and round side of the block were used to sand the concave lines of the leading and trailing edges.

A second coat of CWF was applied on the leading and trailing edges. I was trying to square up and made the edges sharper.

I wouldn't recommend trying to round the edges on flame fins. It would weaken the sharp edges and be near to impossible to fill all the nooks.


Here's all six flame fins stuck down on their root edges for a shot of primer.

No comments:

Post a Comment