You will need the add the SRB struts for strength. These keep the SRBs on the core body when you slide in or pull out the flame fin assemblies.I sealed and painted the dowel white before cutting into eight 1/2" long pieces.
The angle was sanded onto both ends of the dowel.
For a better seam and glue joint, a slight curve was added with a half round diamond file. This will better follow the curvature of the adjoining body tubes.
The ends of the struts got a drop of glue and they were set in place with long tweezers.
Any excess glue was picked up with a Q-tip.
TIP: Q-Tips are great for getting glue out of tight areas where your fingertip can't reach. The only downside, you can only use them once. The glue you just removed will quickly dry on the end of the Q-Tip. I always keep them close at hand.
No comments:
Post a Comment