Dr. Zooch SLS Build Part 25 Saturn V Wraps

This picture better explains the longer cut of the lowest wrap.
This is another dry fit before the spray adhesive. You can see where the lower edge of the wrap will cover up the boat tail/body tube seam.





TIP: I've read where others have had problems with the spray adhesive getting everywhere.
If you lightly tape the printed side down an a scrap piece of cardboard there is little chance of the the adhesive getting on the print side.




Here you can see how the wrap is stuck down over the masked body tube section.
You could stick the adhesive down on a painted surface, I think you'll get a better hold on the bare body tube.
There is primer on the tube, but I tend to sand primer down to the surface for better adhesion of all glues used.