Thursday, August 2, 2012

ASP Engine Adapter 13/18 Part 3

The coupler assembly is glued on the center of the BT-5 motor mount tube.

The third ring is glued flush with the forward end of the BT-5 tube. (not shown)

You have to cut out a piece of the fourth, low ring to allow the engine hook movement.
Make one cut and set it over the engine hook to mark the second cut.



Glue the slotted ring flush with the low end of the BT-5 tube.

TIP: The ends of the notched ring won't want to stay down.
Set the ring into a BT-20 tube to hold the centering ring ends down while they dry.





The completed mount.

This A.S.P. mount is much more substantial than the three ring mounts you've seen before.

No comments:

Post a Comment