The tube marking guide was cut out and wrapped around the tube.
It was too small and didn't match up.
The drawings at the bottom of page two were full size.
I extended the lines on the rear view drawing and used that to mark the tube.
The kit includes a small angle to draw the fin lines down the body tube.
The two main fins are to be glued flush with the end of the body tube.
TIP: When the trailing edge of the fins are even with the end of the body tube, go ahead and extend the lines around the back end of the tube. This will make rear alignment much easier as the root of the fin is covering your pencil lines.
No comments:
Post a Comment