The SRB half nose cones were taped down to a scrap piece of cardboard for painting.
These will be painted with gray primer. Gray is the finished color.
I sanded a little off the shoulder that will be covered by the end of the SRB tube.
This made it easier to slide the nose cone halves into place.
Once I was sure all the half cones were recessed to the same depth, a little thin CYA was applied to the sides with the tip of a toothpick.
White glue fillets followed. White glue dries clear and flat.
After all construction is finished, a flat clear spray will be applied.
All the white glue fillets will disappear.
No comments:
Post a Comment